Beat the Heat! July 07 2016
I just repaired a clipper and had it running with a blade attached for around 20 minutes. The clipper works great, but the blade was as hot as the safety briefing on a Caribbean cruise ship (long story).
There are two main factors that contribute to blade heating.....speed and friction. Clippers are getting faster and more powerful, so try clipping at the lowest speed setting that you can.
You can reduce friction and cool your blades during use by lubricating them with a variety of products such as Andis Blade Care or Wahl Blade Ice. Be sure to oil your blades as well, putting a small amount of blade oil on the contact ride lines between the comb and cutter blades, and don't forget to put a drop or two of oil on the plastic blade guide.
I know that Groomers are all super hot...but that doesn't mean that your blades have to be....Andy
Lots to do! May 09 2016
Hello Monday....it looks like I've got my work cut out for me! When we pick up sharpening it goes into blue bins, and when I get it completed it gets transferred into green bins ('cause green means go). I love a big pile of blue bins but "happiness = green bins".
I am certainly doing my best to tackle the incoming stacks of blue bins so that I can get fully caught up before I get "drunk on a plane" and go "somewhere on a beach" in a couple of weeks (I love country music....it's so relatable).
I hope you all have a good week in spite of the trying times that we are currently experiencing. Take care.....Andy
Happy Easter! March 27 2016
Feast your eyes on these yummy new Andis blades!
Happy Easter everyone .
Give us a try! March 19 2016
Whew! I just finished conquering a massive mountain of blades for a brand new customer.
They wanted to try us out...and gave us 71 blades! Yikes! thanks for the trust, you won't be disappointed
Blade Care February 28 2016
I'm working on (a seemingly never ending pile of) blades today, and it occurred to me that I sure seem to encounter a lot of blades that are corroded and pitted with rust. Sometimes the cutter and comb blades are actually rusted together....it's probably no surprise that they don't perform well in that condition.
There are a number of quality blade coolants, cleaners and lubricants on the market, such as Andis Blade Care, Wahl Blade Ice or Oster Kool Lube, and these products can be used throughout your grooming day.
It is very important that your blades are put away clean and dry when you are done with them for the day. Try blowing out most of the accumulated hair with a high pressure dryer. Then move the cutter blade to one side of the blade and apply a drop or two of clipper blade oil to the "ride surfaces" on the comb blade. Move the cutter blade to the other side of the blade, and apply oil there as well. Then run the blade on your clipper for a few seconds to spread the oil. You can then put the blade away, and be confident that it should work well for you tomorrow.
Happy grooming everyone.....Andy.